What could be done to simplify your router upgrade

Telstra Gateway Frontier modem router press picture courtesy of Telstra

There needs to be a standard filetype to simplify the process of upgrading your home network router without reconfiguring your home network

An issue that will crop up through the life of a home network is to upgrade the router. This will be brought on with replacement of carrier-supplied equipment with retail equipment, replacing that half-dead router that you are always powering off and on many times a week, or upgrading to higher-performance equipment.

But you will end up having to transcribe out configuration data from your old equipment so you can enter it in to your new equipment especially if you want to avoid having to reconfigure other network equipment on your same home network.

Most routers offer a way for users to back up the current configuration details. This is typically to allow a user to do things like perform a factory resent or to test a configuration without losing a prior known-to-work state.

The process typically requires the user to download a configuration file to the computer they are configuring the router from in a similar manner to downloading a resource from the Web. But there isn’t a consistent file schema for storing this data in a manner for transferring to devices supplied by different vendors. In some cases, you may not be able to transfer the configuration data to newer equipment from the same vendor such as to install a newer router model.

AVM have taken steps in the right direction by allowing users to save a configuration from an older Fritz!Box router and upload it to a newer Fritz!Box router running a newer version of the Fritz!OS firmware. It is also to factor in allowing the router to persist your configuration to a newer version of the firmware.

But what can be done to make this work better would be to use a standard file format, preferably an XML-based schema which could be used for storing a router configuration. This would have to be agreed upon by all of the vendors to provide true vendor interoperability.

There would also be issues about providing multiple methods of storing this data. It could be about maintaining the traditional HTTP download / upload approach with Web clients on the same local network. Or it could also be about transferring the data between a USB Mass Storage device and the router such as to facilitate an out-of-box install.

Such a setup could allow for a range of scenarios like simplifying the upgrade path or to make it easier for support staff to keep information about different configurations they are responsible for.

The configuration data would have to cater for WAN (Internet) and LAN details including details regarding Wi-Fi wireless network segments, advanced network setups like VLAN and VPN setups, VoIP endpoint setups as well as general and security-related data.

Of course an issue that will crop up would be assuring the user of proper network security and sovereignty, something that could be assured through not persisting the management password to a new router. Also you won’t be able to keep Wi-Fi channel data especially if you deal with self-optimising equipment, because you may have to face an evolving Wi-Fi spectrum landscape.

What will need to happen is to provide methods to allow seamless upgrading of devices that serve as your network-Internet “edge” so you can simplify this upgrade process and get the most out of the new equipment.

Leave a Reply